Combination of sliding door series (configuration center track)
2014/4/16 16:14:51
Single tang combination of slip at the gate by a block of steel and non-insulation door combination, such combination door run:
Along the the buildings interior wall facing the slide on the movement or upward glide and then run to the buildings ceiling.
When access to buildings with more than a certain width (typically greater than 10 meters), you can configure two or more sets of combinations in the channel mouth sliding doors, each sliding door between the center of the track to move along the direction of the door width.
Two or more sets of sliding doors link to become a super-wide door.
Center of the track on both sides of the sliding doors can run up to the building center rail power driven or manually operated mobile to the channel port side (or both sides), when the center of the track is completely moved to the the channel port side (or two side), the channel port is fully open.
The formation of a wide channel mouth. When the need to close the channel mouth should first control channel port side (or both sides), the center of the track is moved in the direction of the center of the door width
When the center track is moved to the predetermined position, and after positioning lock.
At this point it can be controlled independently sliding doors along the movement has been installed in the center of the track and building structures on both sides of the channel mouth, slide down to the door fully closed position. Such an extra-wide mouth of the channel will be shut down completely.
Typically, a central track need to install two sets of vertical rails up to run for the adjacent two sets of sliding doors.
The center of the track can be based on the actual channel port width configuration of one or more sets.
Along the the buildings interior wall facing the slide on the movement or upward glide and then run to the buildings ceiling.
When access to buildings with more than a certain width (typically greater than 10 meters), you can configure two or more sets of combinations in the channel mouth sliding doors, each sliding door between the center of the track to move along the direction of the door width.
Two or more sets of sliding doors link to become a super-wide door.
Center of the track on both sides of the sliding doors can run up to the building center rail power driven or manually operated mobile to the channel port side (or both sides), when the center of the track is completely moved to the the channel port side (or two side), the channel port is fully open.
The formation of a wide channel mouth. When the need to close the channel mouth should first control channel port side (or both sides), the center of the track is moved in the direction of the center of the door width
When the center track is moved to the predetermined position, and after positioning lock.
At this point it can be controlled independently sliding doors along the movement has been installed in the center of the track and building structures on both sides of the channel mouth, slide down to the door fully closed position. Such an extra-wide mouth of the channel will be shut down completely.
Typically, a central track need to install two sets of vertical rails up to run for the adjacent two sets of sliding doors.
The center of the track can be based on the actual channel port width configuration of one or more sets.
